South Salem Cycleworks: Salem, Oregon
(503) 480-2001
email: sscycleworks@comcast.net
We have a huge stock of vintage and modern parts. Contact us!

Vintage Components - Campagnolo accessories & small parts

Campagnolo accessories & small parts on this page: Quick-release seatpost binder bolt | Campagnolo 8mm seat post binder | Tange replica of Campy 8mm seat post binder | Miche replica of 10mm Campy seat post binder | Generic/replica seat post binder | Steel pump head | Plastic pump head | Pump umbrella clip | Downtube double cable guide | Downtube cable stops for frames with braze-on shifter bosses | Downtube shift lever stops for frames with braze-on shifter bosses | Top tube brake cable housing clamps | Adjusting screws for short 1010B dropouts | Dropout adjusting screw cap | Ergobrain cadence magnet

We also have: Campagnolo front derailleurs | Campagnolo rear derailleurs | Campagnolo shift levers

Campagnolo poster

From a long time ago in a place far away, a poster of classic Campagnolo fittings.


Campagnolo Quick-release seatpost binder bolt. New, $40.00

Part# 44109

We also have one from Specialized.

  • Campagnolo part #1240
  • We have four in stock.
  • The shaft is 8mm in diameter. Many QR's have smaller shafts.
  • These were made from the 1960s into the 1980s.
  • Great for tandem stoker seats.

Campagnolo seat clamp

Given the curved lever, this clamp was probably made in the 1980s.

Campagnolo seat clamp

Let there be no doubt as to who made this.

Specialized quick-release seatpost binder bolt. Used, $40.00

Specialized seat post QR

Here's Specialized's offering

Spcialized seat QR

The lever


Campagnolo 8mm seatpost binder bolt. Lightly used, $70.00/each

  • We have two in stock.

ampagnolo seat binder bolt

The classic.

Campagnolo seat post binder bolt

Small in size, but big in character.

Campagnolo seat biner

End view.


Tange seat post binder bolt. New, $25.00/each

Part# 44196

Not quite the same as the old Campy bolt, but not nearly the same price either. And it will do the same job quite well.

  • 19mm length measured inside-to-inside when the bolt is closed
  • It is intended to be a replica of the Campangolo 8mm seat binder bolt
  • If your seat lug doesn't have a keyway, just a round hole, these binders are just the ticket.
  • These bolts have a knurled section to help them grip the inside of the seat-lug ear.

Tange seat post binder bolt

A classic design

Tange seat post binder bolt

The seat post binder bolt turned over

Tangle seat post binder bolt

End-on view. Note that it is made of cro-moly steel.


Miche 10mm seat post binder bolt. New, $20.00

  • This bolt measures 22mm inside-to-inside when the bolt is closed
  • It is intended to be a replacement for the Campangolo 10mm seat binder bolt
  • If your seat lug doesn't have a keyway, just a round hole, these binders are just the ticket.
  • These bolts have a knurled section to help them grip the inside of the seat-lug ear.

Miche Seat post binder bolt

Made in Italy

Miche seat post binder bolt

The other side


Campagnolo replica seat binder bolt. $15.00/each

Not quite the same as the old Campy bolt, but not nearly the same price either. And it will do the same job quite well.

  • This is a 10 x 22mm seat binder bolt
  • If your seat lug doesn't have a keyway, just a round hole, these binders are just the ticket.
  • These bolts have a knurled section to help them grip the inside of the seat-lug ear.

Allen seat binder bolt

View 1

Allen seat post binder bolt

And from the other side


Campagnolo Steel Pump Head.

  • Campagnolo part# 1030/2

We have four: #1 | #2 | #3 | #4

Campagnolo Steel Pump Head #1. Used, $25.00/each

Campagnolo steel pump head

The classic.

Campagnolo steel pump head

The pump head's underside

Campagnolo steel pump head

Side view

Campagnolo steel pump head

From the other side.

Campagnolo steel pump head

It doesn't have its little blue feet.

Campagolo steel pump head

The pump head's business end.

Campagnolo Steel Pump Head #2. Used, $35.00/each

Campagnolo steel pump head

The classic.

Campagnolo steel pump head

This pump head no longer has its blue rubber feet.

Campagnolo steel pumphead

The working side.

Campagnolo steel pump head

The toher side of the pump head.

Campagnolo Steel Pump Head #3. Lightly used, $70.00/each

Campagnolo steel pump head

Lovely condition, with its rare blue feet.

Campagnolo steel ;pump head

Here's the same pump head turned around.

Campagnolo steel pump head

The grommet side.

Campagnolo steel pump head

And here it is turned 180 degrees.

Campagnolo Steel Pump Head #4. Used, $20.00/each

Can a classic all-Campagnolo bike be called that without a Campangolo pump head?

Campagnolo steel pump head

Side view

Campagnolo steel pump head

Front view

Campagnolo steel pump head

The valve end.


Campagnolo plastic pump head. Used, $30.00/each

Campagnolo plastic pump head

The business end of this pump head.

Campagnolo plastic pump head

Side view.

Campagnolo plastic pump head

The end that connects to a Silca pump.

Campagnolo plastic pump head

And the other end.


Campagnolo Umbrella pump clip

Campagnolo part# 632

We have two: New | Used

Before frame-fit pumps came out, in either the very late 1970s or early 1980s, one needed a Campagnolo umbrella clip to hold a Silca Impero pump on a frame.

Campagnolo Umbrella pump clip. New, $50.00

Campagnolo pump clip

Note this has a rare reinforcement ring

Campagnolo pump clip

And the underside

Campagnolo Umbrella pump clip. Used, $20.00

Part# PC-01

Campagnolo umbrella  pump clip

Here's the way your pump would see the clip

Campagnolo pump clip

Side view


Campagnolo downtube double cable guide. used $35.00

This is wonderful piece of design. At the time, in the 1960s, it may have been the only cable guide that made cable housing for the front derailleur unnecessary.

We have: New | Used

Campagnolo downtube double cable guide. New, $50.00

Part# 85701

Campagnolo downtube cable guide

Nice and new and shiny

Campagnolo cable guide

From another angle

Campagnolo downtube cable guide

And the side that guides the rear derailleur cable.

Campagnolo downtube double cable guide. Used

We have three: #1 | #2 | #3

Campagnolo used downtube double cable guide #1. Used $35.00

Part# CG-01-02

Campagnolo downtube cable guide

This guide doesn't come with the clamping nut and bolt.

Campagnolo used downtube double cable guide #2. Used $35.00

Part# CG-01-03

Campagnolo downtube cable guide

A classic piece of Italian design

Campagnolo cable guide

Here it is flipped around

Campagnolo cable guide

And from the top

Campagnolo used downtube double cable guide #3. Used $30.00

Part# CG-01-04

Campagnolo cable guide

Front view

Campagnolo downtube cable guide

Side view

Campagnolo cable guide

Here's the other side.

Campagnolo downtube cable guide

And inside the guide.


Downtube cable stops for frames with braze-on shifter bosses. New

  • If you want to use Ergopower or fingertip shifters and your frame has braze-ons for downtube shifters, here's what you need.

We have Record/Chorus | Centaur/Athena/Veloce/Mirage | IRD Quick-Release

Record/Chorus downtube cables stop w/barrel adjusters. New, $45.00

Part# 85708

  • Campagnolo part# CAEC-RE001
  • We have 29 sets in stock

Record cable stop

Centaur/Athena/Veloce/Mirage downtube cable stop w/barrel adjusters. New, $35.00

Part# 85707

  • Campagnolo Part# CAEC-AT001
  • We have 18 sets in stock

Centaur braze-on cable stops

IRD Quick Release Downtube cable stops. New, $30.00

Part# 85704

This part makes it easy to pull the cables loose from the frame for either lubricating the cable or making it easier to pack a bike for shipping without loosening the cables from their derailleurs. Neat!

IRD barrel adjusters

The picture shows how this brilliantly designed part works.

IRD quick release

Here's the package front showing the part installed on a downtube


Downtube shift lever stops for frames with braze-on shifter bosses

We do not know who made these stops, but they appear to be in the classic Campagnolo style.

We have them in New | Used

New downtube shift lever stops for frames with braze-on shifter bosses. New, $30.00/set

Shifter stps

Nice and shiny and new

Shifter stops

Here they are turned over.

Used downtube shift lever stops for frames with braze-on shifter bosses. Used, $20.00/set

Shifter stops

A simple, but necessary part if the bike has shifter bosses and you want to use downtube shifters.

Downtube shifter stops

Here they are flipped over


Campagnolo top tube brake cable housing clamps.

We have these classic clamps in New | Used

Campagnolo new top tube brake cable housing clamps. New, $50.00/set

Part# 85700

  • We have seven sets in stock.

Campagnolo top tube cable clamps

Essential parts for bikes of a certain age.

Campagnolo cable clamps

Here's one set

Campagnolo top tube cable clips

A close-up of the clips

Campagnolo top tube cable clips

Top view

Campagnolo cable clips

Classic, perfect Campagnolo design

Campagnolo brake cable clips

A last look...

Campagnolo used top tube brake cable housing clamps.

Set of three | Individual clamps

Campagnolo used top tube brake cable housing clamps, set of 3. Used, $15.00/Set

Campagnolo brake cabel clamps

These clips are used, but are ready for many more miles.

Campagnolo brake cable clips

These always look so elegant on a bike with a brake cable on the top of a top tube.

Campagnolo brake cable clamps

The insides of the clamps.

Campagnolo used top tube brake cable housing clamps. Used, $15.00/each

  • We have two individual clamps in stock

Cable clamps

View one.

Campagnolo top-tube cable clamps

And another view


Adjusting screws for short 1010B dropouts. New $16.00

Part# 63326

  • Campagnolo part# 1134006
  • Plated, knurled end nuts are not included
  • First listed in the 1978 Campagolo supplement catalog

Campagnolo 1010B adjusting screws


Campagnolo dropout adjusting screw cap. New, $5.00

Campagnolo adjusting screw cap


Campagnolo Ergobrain cyclocomputer cadence magnet. New, $15.00

Part# 09501

Ergobrain cadence magnet